Feed speed of 11 meters/36 FPM. - Equipped with: Operator control panel at eye-level, height adjustment with top pressure beam for all workstations; electronic line control (no limit switches), digital height indicator on holddown beam, electronic motor brakes on trimmers.
Automatic magazine for strip and coil feeding.
Panel pre-heater (direct contact style) for achieving optimal bonding quality.
Hot melt granulate glue application system with 12 minute heat up time and no lubrication needed.
Glue unit heating is turned off if no work piece is run within 9 minutes. Glue unit heating is also turned off 3 minutes after the safety cover is opened and control voltage is not re-activated.
0.4 - 3 mm (1/8") Edge thickness cap., 8 - 50 mm panel thickness, 60 mm min. panel width and 140 mm min. length.
Equipped with: Hot Melt granulate glue system with fast start-up (10 - 12 Min heat-up) (when idle drops to 150°it takes 2-1/2 Min to re-activate).
3 mm PVC Pneumatic guillotine for coil cutoff, automatic feed magazine, coil stock feeds automatically with guillotine cutoff, all strip stock are fed automatically through strip feed magazine.
3-Roller pressure section (1st driven, 2 idle) w/electronically controlled & feed speed synchronized drive roll.
Workstations: Vertical travel double motor front & rear end trim with 0° - 15° horz. bevel cap. (0.25 HP - 12,000 RPM motors);
Top & bottom flush/bevel trimmers (0.35 HP - 12,000 RPM motors),
bevel 0° to 15°;
Last Station: Top & bottom buffing unit (0.15 HP - 2,750 RPM motors).