HOME ABOUT US CONTACT US NEW MACHINERY USED MACHINERY FINANCING HOFMANN SEMINARS & PRESENTATIONS **LIQUIDATION SALE**
USED MACHINERY
Browse by Application:


SOLD
View All 9 Photos      View Slideshow









1512-02

Brandt Edgebander with Scraping and Buffing (Used)

Model: KDN 210SB; SN: 0-250-34-xxxx; Year: 2008.
208/230/460v; 3ph; 60.

VIDEO

Equipped with Electronic Line Control.

0.4 - 3 mm (1/8") Edge thickness cap., 8 - 50 mm panel thickness, 60 mm min. panel width and 140 mm min. length.

Equipped with: Hot Melt granulate glue system with fast start-up (10 - 12 Min heat-up) (when idle drops to 150°it takes 2-1/2 Min to re-activate).

10 meters/minute (33 FPM) feed speed.

Automatic height adjustment with top pressure beam for all work stations.

Equipped with digital height indicator for setting of upper pressure beam.

Control panel located at machine infeed for operator convenience.

Large coil table (800 mm diameter) to accommodate 3mm PVC coils.

Automatic magazine for strip and coil feeding.

Hotmelt granulate glue application system with approximately 12 minute heatup time.

Automatic reduction of glue temperature if not run within 15 minutes. This feature lowers the temperature to approximately 150 degrees C

Reversible glue roller application.

Strengthened pre-cutter for cutting 3 mm PVC from the coil.

First pressure roller driven and two free-spinning pressure rollers equipped with digital setting system.

Double motor end trimming unit with straight and chamfer capability.  Chamfer up to 15°.  Program controlled pneumatic indexing from straight to bevel

Fine trimming unit with auto-tilt and digital “Quickset” system.  Includes combination Dust Flow Control straight/3 mm radius insert cutters. 

Equipped with pneumatically-indexed scraping unit with top, bottom and side tracing device for finishing thick PVC edges.

Top and bottom buffing unit.

Workpiece support track extendable to 13.8” ( 350 mm ).

Electronic frequency changer for all trimming motors, which also includes electronic motor braking.

Electrical components according to UL/CSA listings.




$11,500.00


Replacement cost: $35,000.00, (approx.).
FOB: Hudson, NY
This machine is offered “in good running condition as taken from service” and is subject to prior sale.
Specifications are approximate and to the best of our knowledge. Verification is available upon request.