Setting up a tilting shaper can be a major challenge. Not so for the T27 FLEX with its modern touchscreen controller. Thanks to the controllers integrated tool conversion, the operator can make efficient use of the wide tilting range of the T27 FLEX (2 x 46°), allowing them to set up even complex moulding patterns with a tilted spindle in a flash.
No matter whether you work with the spindle tilted to the front or to the back, the controller prompts you in setting up the shaping process. Cutting height, cutting angle everything is structured in an obvious way for the operator. After activating the tool, the controller will indicate the location to reference the tool in relation to the table and fence jaws. In this way, setup procedures that used to be very time-consuming can be performed rapidly a major step in the direction of more flexibility and efficiency for the operator.
Perfect results on six axes
|Table size 1255 x 900mm ribbed cast iron||Table height 900mm||Table openings 255/205/161/106/74mm|
|Tools with max diameter 250mm (150mm||for 45 degrees tilt) below table||Rotational speeds 3000/4000/5000/6000/8000/10000rpm|
|Motor power 10HP||Control panel Foldable, at eye level||Control PowerPC acording to industry Standard|
|Cutter spindle DormFix quick change system||Spindle stroke 150mm (125mm for 13hp motor)||Tool diameter Max 250mm in fence; 350mm in tenon guard|
|Extraction 2 x 120mm||Extraction requirement 840cmh||Control properties:|
|Touch-Screen - user interface 5.7" (145 mm), colour TFT (8-bit colour depth)||Electronically controlled cutting height (spindle), full integration of cutting height in the control and program memory; repetition accuracy of +/- 0.025mm||Electronically controlled cutting angle (spindle), tiltable by + / - 46 degrees, full integration of cutting angle in the control and program memory; repetition accuracy of +/- 0.005mm|
|Integrated display of fence position cutting depth||Integrated display expandable with following additional controlled axes (maximum 6 axes):||Cutting depth (total fence);|
|fence jaw, right (chip)||table rings||feeder support height|
|Easy-to-handle display and intuitive operation of up to five axes on the HOME page||Display and operation of the sixth axis on 2nd page of control||Conversion and digital display of tool position (cutting height/cutting depth) in relation to table and fence based on stored tool data|
|Tool data memory for 500 tools, 3 reference points can be stored for each tool - simple to enter and use adjustable tools||Program memory for 100 tool positions of all digitally displayed axes||Simple tool and program selection via alphanumeric search function|
|Fully automated referencing of axes cutting height and cutting angle (T27 FleX)||Controlled and manual movement of the motorised axes possible; if two ore more values exist (i.e. height and depth of a chamfer) all axes can be posititioned directly one after the other.||Selection of the cutters' rotational direction (right/left); status display for standard rotational direction (right)|
|Display for rotational speed, tool name, spindle rings, and current cutting speed||Integrated calculator with axis-related memory option, integrated operating time counter||Diagnosis and help menu with operating information|
|Customization possible for all languages using Latin/Cyrillic characters sets||Software key switch / password protection for up to 2 users||USB interface for backup and transfer of program and tool data|